PCAN-Cable 1 & 2
Connection Cable for CAN and CAN FD

PCAN-Cable 1
IPEK-003000
PCAN-Cable 2
IPEK-003001
Description
These cables are needed to set up a CAN bus and are specially designed to be used in a CAN environment. If two High-speed CAN hubs need a simple direct connection between them, the PCAN-Cable 2 with integrated termination can be used. The PCAN-Cable 1 is suitable for putting together a CAN bus which shall contain tap connections and separate termination (PCAN-T-Adapter and PCAN-Term products).
The cables can also be used for CAN FD buses.

Technical Specifications
- 9-pin D-Sub sockets (in accordance with CiA 303-1) at both ends
- Length 2.0 m
- Shield connected to GND
- PCAN-Cable 1 without termination resistors
- PCAN-Cable 2 with 120-Ohm termination resistors
- Suitable for the use in CAN FD buses
Scope of Supply
- PCAN-Cable
Other lengths and special cable makeup on request.