The FloPro XCi can be used to monitor just about any water quantity and quality sensor, together with vital mining, municipal, and industrial equipment and assets. Whether you need to measure flow, conductivity, pH or rainfall, or use a non-contact level sensor to measure pond levels, the FloPro is fully expandable to your meet needs.
Optimized Cost of Ownership
In-Situ’s Doppler Insertion Sensor combines easy installation with low-cost maintenance and built-in tamper resistance.
Complete Monitoring Solution
In-Situ’s complete monitoring solution, with HydroVu, XCi controllers, flow sensors, batteries, solar panels and mounting adapters works better than any pieced-together solution.
Run up to five sensors from a single device to expand as your business grows. Cost per monitoring system is significantly less than the cost for competitors’ systems.
The XCi system expansion cards enable the system to integrate with any SDI-12 devices or pulse meter.
The XCI platform is telemetry ready. The integrated WebComm card enables data communication over GSM cellular networks. Get the real-time visibility you need through HydroVu’s Network-Wide Visibility, Multi-Condition Alarms, Dashboards and Calculated Parameters functionality.
Integrated Flume & Weir Equations
FloCom+ provides the equations for all standard pipe and structures built into the software.
With MASP Technology sensors see the full pipe and use continuous-wave Doppler and advanced signal processing to give an average velocity across the whole stream profile in pipes up to 100 inches in diameter.
Use the ZX SnapStrap to install a Doppler ultrasonic sensor inside pipes ranging in size from 225mm (8?) to 810mm (32?) in minutes.
Collect accurate process chemistry measurements and water monitoring data to ensure system optimization and compliance.
Monitor level, quality and flow continuously to establish baseline parameters and see changes during storm events.